Digital Watchdog Starlight D1363D Technical Information PDF herunterladen (Seite 49)

DHCP Client Information

If and only if this interface is a dhcp client, then you can access information regarding the active lease.

or renew the lease information (see fig 15). This is grayed out when dhcp client is not active.

fig 15: dhcp client information/renewal

802.1q Virtual Lan (VLAN) Setup

The VLAN setup is accessed from the interfaces menu (see fig 2). When selected, a setup box appears

(see fig 16). VLAN's are frames that carry special tags in the headers. You can tag traffic with VLAN

0 to 4094, but if you have any Cisco gear, you should not use either 0 or 1.

The VLAN is attached to a physical device (ether1, ether2, wpci1, wpci2, etc.).

The reorder header checkbox should not be selected unless you have a problem with DHCP leases.

Some DHCP servers require the headers reordered, but try without first.

You may also change the MAC address associated with VLAN traffic. This too, is often not a good

idea unless you have a specific reason to do so.

The virtual device created then has a submenu similar to the physical devices. Here, you can change

the MTU if you have problems passing larger packets, assign IP addresses, bridge them to other

devices.

VLANs are used when you need to run two networks over the same wire or wireless link, but want to

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 101 102

Keine Kommentare

Digital Watchdog Starlight D1363D Technical Information Seite 49